-
When using power equipment follow safety procedures.
-
After drilling holes or cutting the Novabrik, brush off any dust or concrete
chips that may remain on the brick.
-
Before installing the house wrap, mark down the location of the studs on the
bottom horizontal furring strip, this way you will know where exactly you have
to fasten the furring strips.
-
If the screw does not draw in to the furring strip properly, it is probably
because you have not hit the stud. Move your screw and reinstall.
-
Hold down the face of the brick when fastening the Novabrik. This will
prevent the brick from kicking out when fastening the bricks to the wall.
-
Give a firm rubber hammer strike down on a 2" x 4" setting on the bricks,
before fastening the bricks and tap the face of the bricks. This will set and
level the brick before you fasten the brick.
-
Wet saws make less dust, rinse brick with clean water after using a wet saw.
-
A 14" blade will allow you to cut 2 bricks at the time.
-
Use two separate drills, one for screwing and the other for drilling into the masonry (SDS hammer drill).
-
Have a good pair of snips to cut the trims.
Preparation Tips
